Skip to content
Sutter Butte Dusters

Crop nutrition

Soil sampling: how to take a sample you can trust

By the Sutter Butte Dusters team · · 9 min read

A mapping drone above a field with an Ag Cat biplane parked behind

Soil sampling decides whether a soil test helps you or misleads you. The lab measures only the soil that you send, so a careless sample gives an exact number that does not describe your field. This guide gives the depths, core counts, dates and test thresholds from UC and CDFA research for Sacramento Valley crops.

Why does the sample matter more than the lab?

The sample is a very small part of the field. The CDFA wheat fertilization guidelines convert 1 ppm of nitrate nitrogen in 1 foot of soil to about 4 pounds per acre. So an acre-foot of soil weighs about 4 million pounds, and the lab gets about one quart.

That quart can describe the field only if it is a composite. A composite sample is many small cores, mixed in one bucket, from one uniform area. Keep these spots out of the main sample:

  • Old fence lines and farmstead sites
  • End rows, corners, wet spots and eroded spots
  • Rice levees and the edges of the check
  • Fertilizer bands and drip-tape strips, unless you sample them on purpose

If one of these areas is large, sample it separately.

When should you soil sample in the Sacramento Valley?

Sample before you apply fertilizer, and sample in the same season every year. The table shows when to soil sample for the main valley crops.

CropP, K, pH and saltsNitrateTissue
RiceBefore flooding and preplant fertilizerNot usefulY-leaf at panicle initiation
AlmondsFall, every 3 to 5 yearsSpring, every year36 to 48 days after full bloom, and July
Walnuts and prunesFall, every 3 to 5 yearsSpring, every yearJuly
PeachesFall, every 3 to 5 yearsSpring, every yearJune to July
Processing tomatoesFall or springBefore the first nitrogenFourth leaf from the tip, from first bloom
WheatFall or springNear planting or before the first topdressStems, 3- to 4-leaf stage to boot

Sources: CDFA Fertilizer Research and Education Program (FREP) crop guidelines; Soil Sampling in Orchards (CDFA FREP, 2016); FREP orchard tissue guide.

The orchard guide prefers fall, because fall leaves time to adjust next year's program. For phosphorus (P), potassium (K), micronutrients and salts, a test every 3 to 5 years is usually enough. A young orchard can have one every year.

Nitrate moves with water and changes with the weather, so the CDFA guides call for a new nitrate test every year. For annual crops, the UC Small Farms Network says to sample after you disc the old crop. If you pre-irrigate, sample after the irrigation.

What soil sampling tools do you need?

A soil probe is the best tool for most soils. A probe is a steel tube that cuts a narrow, even core.

ToolUse
Soil probe or augerMost cores; the CDFA guides name both
Hydraulic probe on a truck or ATVHard, dry or other difficult soil
Spade and knifeNo probe: cut a slice 1/2 inch thick, then trim it to a 1-inch strip
Clean plastic bucket, one per depthMix the cores; galvanized or rubber buckets can add zinc
Paper bagsLeaf and stem tissue, which can mold in plastic

Sources: USDA NRCS fact sheet SD-FS-50 (2022); UC Small Farms Network; CDFA FREP sampling guides.

Clean the probe and the bucket between fields.

Which soil sampling methods fit your field?

Choose the method by how uniform the field is and by what you want to learn.

MethodHow it worksBest use
Composite, or randomCores in a zigzag or W pattern across one uniform areaUniform fields and orchard blocks
ZoneOne composite from each zone of similar soil, yield or crop vigorFields with soil maps, yield maps or crop images
GridOne composite from each square of a fixed gridVariable-rate fertilizer and new ground
PairedOne sample from the poor area and one from good plants next to itA diagnosis, at any time of year

The CDFA orchard guide calls for 15 to 20 cores per block in an established orchard. For a site before you plant, it suggests blocks of 2 to 5 acres with 5 cores each. The CDFA guide for annual crops asks for at least 20 cores per sample.

Zones help when a field crosses more than one soil series. The free UC Davis SoilWeb map shows the soil series in each part of a field. Our drone data service makes multispectral crop health maps, so you can sample weak and strong zones separately.

How deep should you take each core?

Sample to the depth that the research used, or the guidelines cannot interpret the result.

PurposeDepth
Rice: P and KTop 6 inches
Orchard: P, K, saltsFoot increments to 2 feet, halfway between trunk and drip line, in the wetted zone
Orchard site before you plantFoot increments to 2 to 4 feet, deeper if a restrictive layer may occur
Almond: boronTop 6 inches
Tomato: P, K and nitrate1 to 2 feet
Wheat: nitrateFirst and second foot, kept separate

Source: CDFA FREP guidelines for each crop.

Keep each depth in its own bucket, and sample a field to the same depth every time.

Soil sampling procedure, step by step

Use this procedure for one composite sample. Repeat it for each area and each depth.

  1. Mark each sample area on a field map or phone map.
  2. Write down the crop, the last fertilizer and any problem spots.
  3. Remove the plant residue from the spot.
  4. Push the probe straight down to the first depth.
  5. Put the core in the bucket for that depth.
  6. Walk to the next point on the zigzag path.
  7. Take cores until you have 15 to 20 in an orchard block, or at least 20 in a field crop.

Caution: Do not dry soil in an oven or at a high temperature. The CDFA guides warn against it.

  1. Break the clods and mix all the cores well.
  2. Remove stones, roots and plant pieces.
  3. Fill the lab bag with about one quart of the mixed soil.
  4. Label the bag with the field, area, depth and date.
  5. Fill out the lab sheet with the crop and the yield goal.
  6. Ship the sample, or air-dry it or keep it cool until it ships.

The NRCS fact sheet says to air-dry or freeze a sample that you hold for more than a week. It allows 5 to 10 days for the results.

How do you sample a rice field?

Rice needs a shallow soil sample and a midseason leaf sample. The CDFA rice guidelines take soil tests from the top 6 inches, because 70% to 90% of rice roots are in the top 4 inches. Take the cores before you flood the field, and stay away from the levees.

The guidelines say that a preplant soil nitrate test is of little use in rice, so growers test the plant. At panicle initiation (PI), collect the Y-leaf, the newest leaf that is fully open. The guidelines call for about 50 leaves from 30 places early in the season, and 30 to 60 leaves later. Dry the leaves in paper bags at 140 to 160 degrees F.

At PI, the guidelines give 3.0% to 3.2% Y-leaf nitrogen as critical and 3.2% to 3.6% as adequate. A low result is one of two reasons that the guidelines give for a midseason top-dress. Our guide to rice fertilizer top dressing explains that decision.

How do you take orchard tissue samples in July?

The CDFA walnut guidelines say that leaf analysis diagnoses nutrient deficiencies more reliably than soil analysis. Walnut leaf nitrogen falls through the season, but it changes least from late June through July.

CropWhenWhich leavesHow many
AlmondsJulyAt least 8 well-exposed spurs per tree, 5 to 7 feet up28 trees, at least 30 yards apart
WalnutsJulyTerminal leaflets of fully expanded spur leaves, 6 to 8 feet upAbout 50 leaflets from 5 to 10 trees
PrunesJulyNon-fruiting spurs, 5 to 7 feet up1 or 2 leaves from more than 25 trees
PeachesJune to JulyMid-shoot leaves, moderately vigorous new shoots60 to 100 leaves from 30 to 50 trees

Sources: CDFA FREP almond and walnut guidelines; Plant Tissue Sampling in Orchards and Vineyards (CDFA FREP).

The CDFA guidelines give these July leaf nitrogen ranges:

  • Almonds: Adequate at 2.2% to 2.5%, deficient under 2.0%, excessive over 2.7%.
  • Walnuts: Adequate at 2.2% to 3.2%, deficient under 2.1%, excessive over 3.2%.

The tissue guide also gives a spring almond sample, 36 to 48 days after full bloom, from non-fruiting spurs on 18 to 28 trees. The almond guidelines say that a spring sample can predict July leaf nitrogen, which leaves time to adjust the program. For almond boron, a hull sample at harvest is the better test.

A recent spray changes the leaf result, so the tissue guide adds these rules:

  1. Wait at least one week after a nitrogen or potassium foliar spray.
  2. Do not test leaves for a micronutrient that you sprayed on them.
  3. Refrigerate the bags until you ship them.

Tell your adviser the date of each foliar fertilizer application. Our guide to nitrogen deficiency shows the symptoms that a low result can explain.

How do you read soil test results?

Most lab reports give nutrients in ppm, or parts per million. To estimate nitrate nitrogen in pounds per acre, multiply the ppm by 4 for each foot of soil. For example, 10 ppm in the top foot is about 40 pounds of nitrogen per acre.

The CDFA tomato guidelines say that furrow-irrigated tomatoes are unlikely to respond to more nitrogen above 16 ppm nitrate nitrogen in the top 2 feet. The wheat guidelines report a much stronger topdress response when the top foot holds less than 20 ppm at tillering. They add that a plant test alone should not set the nitrogen rate.

TestCropLowMediumHigh
Olsen PRiceUnder 6 ppm6 to 15 ppmOver 15 ppm
Olsen PTomatoesUnder 10 ppm10 to 20 ppmOver 20 ppm
Olsen POrchardsUnder 10 ppm10 to 20 ppmOver 20 ppm
Ammonium acetate KRiceUnder 60 ppm60 to 120 ppmNot given
Ammonium acetate KAlmondsUnder 150 ppm150 to 250 ppmOver 250 ppm
Hot-water boronAlmondsUnder 0.5 ppm0.5 to 1.2 ppmOver 1.2 ppm

Source: CDFA FREP rice, tomato, almond, walnut and prune guidelines.

For P and K in the medium range, the guidelines suggest a rate that replaces what the crop removes. Rice in that range may benefit from phosphorus. For furrow-irrigated paste tomatoes, about 135 ppm exchangeable K is adequate. The orchard guides use the Olsen test above pH 6.5 and the Bray P1 test in acid soils. Wheat after rice is often short of phosphorus, even when the Olsen test reads adequate.

Choose a lab that uses UC test methods, as the UC Small Farms Network advises. Read the results with a certified crop adviser (CCA) or a UC Cooperative Extension farm advisor. Keep each result with a map of the sample areas, so you can track each block over the years.

Soil tests and fertilizer flights in the northern Sacramento Valley

A good sample decides how much fertilizer goes on, and where. In our seven counties, a Y-leaf test at panicle initiation can decide whether a rice field gets a top-dress. We fly dry and liquid aerial fertilizer application, with no wheel tracks in a wet or planted field. When your results call for fertilizer, get a quote for your field.

Get a quote for your field

Questions

Crop nutritionNitrogen deficiency in crops: signs, tests and fixesOrchardsLeaffooted bug in almonds and pistachios: ID and timing

Get on the schedule.

Tell us the field and the job. In a hurry? Call (530) 695-2294, Mon–Fri, 8am–3pm.

PCA with a written recommendation? Send it here.

CallRequest an application