Skip to content
Sutter Butte Dusters

From the hangar

How many acres can a crop duster spray in a day?

By the Sutter Butte Dusters team · · 9 min read

Ag Cat biplane on a low spray pass over a row crop

How many acres can a crop duster spray? The honest answer is a range, and the range comes from simple arithmetic that every ag pilot uses. This post shows that arithmetic with national survey figures and a worked rice example for both of our airplane types.

How many acres can a crop duster spray in a day?

The best national figures come from the operators themselves. In the 2019 NAAA aerial application industry survey, operators estimated the usual and the maximum acres that one aircraft treats in one day. NAAA is the National Agricultural Aviation Association, the trade group for aerial applicators. The table shows the five crops with the highest usual figures.

CropUsual acres per aircraft per dayMaximum acres per aircraft per day
Corn1,1651,925
Forests1,1492,159
Soybeans1,1431,958
Cotton1,1252,119
Rice1,0331,579

The survey data cover the 2017 season and all regions of the country. Most of the aircraft are large: 83 percent of the fixed-wing aircraft in the survey have turbine engines. The days are long too. In season, 55 percent of operators work 8 to 12 hours a day, and 35 percent work 13 to 16 hours.

How much can a crop duster hold?

The hopper is the tank that holds the product, and its size depends on the airplane. The table shows the two types in our fleet. The weight column uses 8.34 pounds per gallon for water, the figure in the USDA aerial calibration chapter.

AirplaneHopper capacityLiquid load in this postWeight of that load as water
Ag Cat400 gallons400 gallonsAbout 3,340 lb
Air Tractor 602630 gallons500 gallons, our usual maximumAbout 4,170 lb

The flight manual sets a weight limit for each airframe. Heat, a heavy mix or a short airstrip can lower the safe load. Dry products fill the hopper by weight, not by gallons.

Our guide to crop duster planes covers other ag aircraft, and Air Tractor 602 vs Ag Cat compares our two types.

How many acres can a crop duster cover per load?

The carrier volume is the total gallons of spray mix that go on each acre. To find the acres per load, divide the gallons in the load by the gallons per acre.

Gallons per acreAcres per 400-gallon loadAcres per 500-gallon load
2200250
580100
104050
15About 27About 33
202025

The label often sets a minimum volume. For propanil, a rice herbicide, the UC IPM rice herbicide treatment table lists 10 to 15 gallons of water per acre by ground or air. UC IPM states that the higher volume gives better coverage on large grasses and dense weeds. At those volumes, one Ag Cat load treats 27 to 40 acres.

Your licensed pest control adviser (PCA) writes the volume on the recommendation, inside the range on the label. Our post on herbicide application in rice explains coverage in flooded fields.

How wide does a crop duster spray?

The swath is the width of ground that one pass treats. It depends on the airplane, the nozzles and the spray mix. The spray spreads as it falls, so the swath is wider than the boom.

The pilot sets the swath from a pattern test, which measures where the spray lands across a line of collectors. The 2019 NAAA survey report gives 99.3 percent for GPS swath guidance, which places each pass beside the last one.

Swath width also tells you the acres in each mile of flight. The USDA chapter divides the swath in feet by 8.25 to get acres per mile. A 50-foot swath treats about 6.1 acres per mile, and a 60-foot swath treats about 7.3 acres.

How fast does each airplane work?

Our Ag Cats work at about 95 mph with a full hopper and a spray boom. That is our working figure from the field, not the maximum speed of the type. For the AT-602, Air Tractor lists a typical working speed of 145 mph. This post uses 95 mph and 145 mph for both the spray passes and the ferry flights.

How many acres can a crop duster spray in an hour?

There are two answers: the spray rate and the work rate. The spray rate counts only the time when the boom is open. To get acres per minute, the USDA chapter multiplies the speed in mph by the swath in feet and divides by 495.

SwathAcres per minute at 95 mphAcres per minute at 145 mph
50 ft9.614.6
60 ft11.517.6
70 ft13.420.5

No airplane sprays for a full hour. Turns, ferry flights and reloads take most of the clock. The work rate counts all of that time.

Worked example: a 160-acre rice field

Ferry time is the flight between the airstrip and the field. The inputs are examples, not the settings for a real job.

InputAg CatAir Tractor 602
Load400 gallons500 gallons
Gallons per acre10, inside the UC IPM range for propanil10
Field160 acres, passes half a mile (2,640 ft) longSame field
Swath (example)50 ft60 ft
Speed95 mph145 mph
Turn at the end of each pass (example)30 seconds40 seconds, because a faster airplane makes a wider turn
Reload on the ground (example)5 minutes5 minutes
Ferry, each way17 miles, our strip to Colusa17 miles

These steps work out one Ag Cat load:

  1. Divide 400 gallons by 10 gallons per acre. One load treats 40 acres, so the field needs 4 loads.
  2. Multiply 95 mph by 50 feet and divide by 495. The result is 9.6 acres per minute.
  3. Divide 40 acres by 9.6. The spray time is about 4.2 minutes per load.
  4. Find the acres per pass. Each half-mile pass treats about 3 acres.
  5. Count 14 passes for each load. At 30 seconds each, the turns take 7 minutes.
  6. Add the ferry. A 34-mile round trip at 95 mph takes about 21.5 minutes.
  7. Add 5 minutes to reload. Each load takes about 37.6 minutes in total.

The Ag Cat treats 40 acres every 37.6 minutes, or about 64 acres per hour. The same steps give the AT-602 about 31.2 minutes for each 50-acre load, or about 96 acres per hour. For both airplanes, the ferry is the largest part of each load. The table shows three ferry distances.

Ferry distance, each wayAg Cat acres per hourAg Cat time for 160 acresAT-602 acres per hourAT-602 time for 160 acres
2 milesAbout 128About 1.25 hoursAbout 159About 1.1 hours
17 milesAbout 64About 2.5 hoursAbout 96About 1.9 hours
34 milesAbout 41About 3.9 hoursAbout 66About 2.9 hours

Why are the national averages higher than this example?

The NAAA figures include low-volume jobs, large turbine airplanes and long days. The table gives 6 hours of flying on the same field shape. Only the volume and the ferry change.

JobAg Cat acres in 6 hoursAT-602 acres in 6 hours
10 gallons per acre, 17-mile ferryAbout 380About 580
10 gallons per acre, 2-mile ferryAbout 770About 960
2 gallons per acre where the label allows it, 2-mile ferryAbout 1,170About 1,350

At 2 gallons per acre, both airplanes pass the NAAA rice average of 1,033 acres. At that volume, the turns take more time than the spray, so longer passes help most.

What lowers the acres per day?

Most limits on the daily acres come from the field, not the airplane.

  • Small or odd-shaped fields. Short passes mean more turns for each acre.
  • Obstacles. Power lines, trees and nearby homes add cleanup passes.
  • Wind and temperature. The label can set weather limits, and the pilot waits when the weather is wrong.
  • A change of product. The crew may need to rinse the hopper before it loads a different product.
  • Hot days. Hot air reduces climb performance, so the pilot may carry a smaller load.

Read spray drift in aerial application for the weather limits and how to prepare your field for aerial application.

How can you estimate the time for your own field?

Caution: use the result only as a rough guide. The pilot and the label set the real swath, speed and load.

  1. Get the PCA's written recommendation with the product and the gallons per acre.
  2. Divide the load in gallons by the gallons per acre. This gives acres per load.
  3. Divide the field acres by the acres per load. Round up to get the number of loads.
  4. Measure the straight-line miles from the airstrip to the field.
  5. Multiply the round-trip miles by 0.63. This gives Ag Cat ferry minutes at 95 mph.
  6. Add spray time, turn time and 5 minutes of reload time for each load.
  7. Multiply the minutes per load by the number of loads.

Our guide to crop dusting cost per acre explains how volume, ferry and field shape affect a quote.

How far is your field from our airstrip?

Ferry time changes most across our service area. Our strip at 4080 Clark Rd is about 3 miles south-southwest of downtown Live Oak, at 39.2317 N, 121.6888 W. The table gives the straight-line distance from the strip to each county seat, and the one-way time, rounded up.

CountyCounty seatMiles from our stripAg Cat at 95 mphAT-602 at 145 mph
SutterYuba City75 minutes3 minutes
YubaMarysville86 minutes4 minutes
ColusaColusa1711 minutes8 minutes
ButteOroville2114 minutes9 minutes
GlennWillows3422 minutes15 minutes
YoloWoodland3824 minutes16 minutes
PlacerAuburn4026 minutes17 minutes

Your field can be closer or farther than its county seat. See our Colusa County page for one of the largest rice counties in California.

When do Sacramento Valley crop dusters cover the most acres?

The busy season in our area runs from April to July, and each month brings a different limit. The 2021 UC Davis rice cost study shows the aerial jobs on a typical Sacramento Valley rice farm. Our season calendar adds orchards and other crops.

MonthsAerial jobs in the UC rice studyWhat limits the acres per day
April 20 to May 20Rice seeding at 175 lb per acre onto flooded fieldsSeed fills the hopper by weight
MayGrass herbicide on all acres; algae and seedling pest control on part of the acresThe label rate and the PCA recommendation for each product
JulyDry fertilizer top-dress on 75 percent of acres; armyworm control on 25 percentFertilizer fills the hopper by weight
July and AugustOne fungicide flight on most acresMany fields that reach the same stage at the same time

How this works from our Live Oak strip

We fly five Ag Cats and one Air Tractor 602 from 4080 Clark Rd in Live Oak. You can see them on our fleet page. Six airplanes let us split a large job or work several fields on the same day. We fly rice, orchards and row crops in all seven counties, usually within 24 hours of your call. Send us the field, the acres, the product and the gallons per acre, and we will plan the loads. Get a quote for your field.

Get a quote for your field

Questions

Crop nutritionNitrogen deficiency in crops: signs, tests and fixesOrchardsLeaffooted bug in almonds and pistachios: ID and timing

Get on the schedule.

Tell us the field and the job. In a hurry? Call (530) 695-2294, Mon–Fri, 8am–3pm.

PCA with a written recommendation? Send it here.

CallRequest an application